Backup your Windows registry! The PCT uses 2 small chips to provide a programmable interface to the telephone line, and does not use relays, transformers, or opto-isolator which makes this a very low cost modem. To rectify this annoyance, add the latter response and assign the following data to it: MoH only works once during the session. Exit regedit The aforementioned hack will cause lines such as the following to be appended to the end of every modemlog: However, the diagnostic information is lost when you disconnect the modem. Additional links that may help:
|Date Added:||10 April 2011|
|File Size:||37.37 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
This can be corrected by editing the. As of Feb ’04, Dell supplies V. Richard writes to BestData: Here’s a Win9x registry hack from Franc Zabkar that results in the ptel information being written to the modemlog immediately prior to hangup:. This will cause the modem to ignore a DTR drop: Ideally, people should compile the kernel immediately prior to compiling modules to ensure success.
Modems based upon these chipsets can be made ajr notebook computers as well as other non-PCI form factors. Cisco remote access has 2 available modems – Microcom and Mica.
We have seen this happen with a few systems and it is apparently an incompatibility with the OS, motherboard, and the modem. I allowed plenty of time between calls so that the modem was finished retraining.
Exit regedit The arm hack will cause lines such as the following to be appended to the end of every modemlog: To rectify this annoyance, add the latter response and assign the following data to it: I think it’s unlikely that Conexant will continue to develop 2 lines of chipsets: Linux drivers are available from: You can do this in the DUNs Connectoid.
In the case of Win2K and XP, UD info is automatically written to the modemlog with at least some pcetl the drivers see last note belowso a hack is not required. The pages on this site include the appropriate commands for PCTel modems.
Here’s a Win9x registry hack from Franc Zabkar that results in the diagnostic information being written to the modemlog immediately prior to hangup: I recently purchased the modem and called myself from my cell phone to familiarize myself with v.
Max Hopper in Ireland reports being frustrated with garbled Modemlog output and too much time on his hands – and came up with discovery that adding 2 registry keys enables Unimodem.
This command will first capture the UD report, and then hang-up the line.
Possible workaround – disable data compression for the modem. WindowsMe will support older Win9x drivers.
PCTel Chipset Modems
However, the diagnostic information is lost when you disconnect the modem. Locate the following key in the registry: And add New Binary values: PCTel sells softmodem business to Conexant. This cannot be done using DUNs. Modem-on-hold is ‘built-in’ to the earlier V. Do you own a PTCtel modem?
Because PCTel modems are all softmodems, the only difference between V. Recent Microcom firmware should support V. There is no space after the G which results in “unrecognized response” in the Modemlog.
Amr-modem FB PCTEL AMR 670
As with any 56k modem, assuming you have a 56k-compatible line, the driver or firmware for your modem is the single most important factor in the quality of your connection. Additional links that may help: As qmr PCtel modems appear to condense the AT UD report into about 10 lines, this means that the entire report is captured.
However, to decipher this info there are two freeware utilities: